24
Various Performance Features
Velocity/Aftertouch
The force with which you play the keyboard, or the “velocity” with which you play, can affect
the volume or timbre of a sound. Aftertouch—downward pressure you apply to a key after
playing a note—can also affect the sound.
fig.02-008
Pitch Bend/Modulation Lever
While playing the keyboard, move the lever to the left to lower the pitch of the currently
selected patch, or to the right to raise its pitch. This is known as
pitch bend
. You can also apply
vibrato by gently pushing the lever away from you. This is known as
modulation
.
If you push the lever away from you and at the same time move it to the right or left, you can
apply both effects at once.
fig.02-009.e
Octave Shift (Oct)
You can shift the pitch of the keyboard in one-octave units over a range of +/-3 octaves by
adjusting the value of the Octave Shift parameter.
Use KEY EFFECT [-OCT] or [+OCT] at the left of the screen to make the desired setting.
To return to the original setting, press both buttons simultaneously.
Hold Pedal
If an optional pedal switch (DP series) is connected to the rear panel PEDAL HOLD jack, you
can press the pedal switch to cause notes to sustain or “hold” even after their keys have been
released.
fig.02-010
There are two types of
aftertouch: Polyphonic
Aftertouch, which applies
aftertouch to individual notes,
and Channel Aftertouch,
which applies aftertouch to an
entire MIDI channel (p. 193).
The Fantom-X can output the
MIDI data for Polyphonic
Aftertouch using the pads, and
Channel Aftertouch using the
keyboard.
For details on the setting, refer
to p. 226.
ModulationPitch Bend
You can set the amount of
pitch change for each patch (p.
67).
For details on the setting, refer
to p. 226.
Fantom-X678_r_e.book 24 ページ ２００５年５月１２日 木曜日 午後４時４０分
To Next Page
Loading...
Need help?
General
