94
Creating a Rhythm Set
fig.07-013_50
For details on these settings, refer to
“How to make Rhythm
Set settings”
(p. 83).
TVA
Tone Level (Rhythm Tone level)
Sets the volume of the rhythm tone. Use this parameter to adjust the
volume balance between rhythm tones.
Value:
0–127
The volume levels of the Waves from which the rhythm tone is
composed is set with the WMT1–4 Wave Level parameter (p.
90).
Level V-Curve (Level Velocity Curve)
You can select from seven curves that determine how keyboard
playing strength will affect the volume. If you do not want the
volume of the rhythm tone to be affected by the force with which
you press the key, select “FIXED.”
Value:
FIXED, 1–7
fig.06-036
Level V-Sens (Level Velocity Sensitivity)
Set this when you want the volume of the rhythm tone to change
depending on the force with which you press the keys. Set this to a
positive (+) value to have the changes in rhythm tone volume
increase the more forcefully the keys are played; to make the tone
play more softly as you play harder, set this to a negative (-) value.
Value:
-63– +63
Tone Pan (Rhythm Tone Pan)
Sets the pan for the rhythm tone. “L64” is far left, “0” is center, and
“63R” is far right.
Value:
L64–0–63R
Set the Pan for Waves comprising the rhythm tones with the
Wave Pan parameter (p. 90).
Random Pan Depth
Use this parameter when you want the stereo location to change
randomly each time you press a key. Higher settings will produce a
greater amount of change.
Value:
0–63
This will affect only waves whose Wave Rnd Pan Sw parameter
(p. 90) is ON.
Alternate Pan Depth
This setting causes panning to be alternated between left and right
each time a key is pressed. Higher settings will produce a greater
amount of change. “L” or “R” settings will reverse the order in
which the pan will alternate between left and right. For example if
two rhythm tones are set to “L” and “R” respectively, the panning of
the two rhythm tones will alternate each time they are played.
Value:
L63–0–63R
This will affect only waves whose Wave Alter Pan Sw
parameter (p. 90) is ON or REV.
TVA Env
A-Env T1 V-Sens (TVA Envelope Time 1
Velocity Sensitivity)
This allows keyboard dynamics to affect the Time 1 of the TVA
envelope. If you want Time 1 to be speeded up for strongly played
notes, set this parameter to a positive (+) value. If you want it to be
slowed down, set this to a negative (-) value.
Value:
-63– +63
A-Env T4 V-Sens (TVA Envelope Time 4
Velocity Sensitivity)
The parameter to use when you want key release speed to control
the Time 4 value of the TVA envelope. If you want Time 4 to be
speeded up for quickly released notes, set this parameter to a
positive (+) value. If you want it to be slowed down, set this to a
negative (-) value.
Value:
-63– +63
A-Env Time 1–4 (TVA Envelope Time 1–4) ,
,
Specify the TVA envelope times (Time 1– Time 4). Higher settings
will lengthen the time until the next volume level is reached. (For
example, Time 2 is the time over which Level 1 will change to Level
2.)
Value:
0–127
Adjusting the Volume (TVA/TVA
Env)
1
1234567
2
1
4
Fantom-X678_r_e.book 94 ページ ２００５年５月１２日 木曜日 午後４時４０分
To Next Page
Loading...
Need help?
General
