Roland Groovebox MC-707

24
Pad Operations (PAD MODE)
Specifying a chord
1.
Use the [C1]–[C4] knobs to edit the value.
Turning a knob: 1 (C-1)–127 (G9)
Pressing a knob: Switches on/o
* To switch between parameter edit pages, press the [FUNC] button.
Parameter Value Explanation
NOTE1–4
OFF,
1 (C-1) –127 (G9)
Specify the notes in the chord.
COLOR *1 Species the pad color.
*1
ORANGE, YELLOW, GREEN, BLUE, PURPLE, PINK, WHITE, SKYBLUE, P.YELLOW,
P.BLUE, P.PINK, L.RED, L.ORANGE, L.YELLOW, L.GREEN, P.GREEN, L.SKYBLUE, L.BLUE,
L.PURPLE
Copying the selected chord
1.
Hold down the [FUNC] button and press the cursor [ ]
button.
This species the chord copy-source.
2.
Hold down the [FUNC] button and press the cursor [ ]
button.
The chord is pasted.
Scatter Mode
You can use the pads to apply Scatter, and edit the eect.
1.
Press the [SCATTER] button.
Scatter mode is selected.
Using the Pads to Apply the Eect
1.
Press a pad.
The eect is applied while you hold down the pad.
The eect diers for each pad.
When you take your hand o the pad, it returns to the previous
state.
Using the [SCATTER] Button to Apply the
Eect
1.
While in Scatter mode, press the [SCATTER] button.
Step mode is selected.
While you hold down the [SCATTER] button, the eects specied
for the steps are applied consecutively, starting from the rst
(momentary mode).
You can also make the eect continue even after you release the
button (alternate mode).
&
For details, refer to “SCATTER” (p. 38).
Recording Eects in Steps
1.
Hold down a step [1]–[16] button and press a pad [1]–[16].
The eect of the specied pad is assigned to the specied step.
In addition to assigning pads to steps, you can also assign each step
its own eect.
&
For details, refer to “SCATTER” (p. 38).
Making Scatter Settings
1.
Hold down the [SHIFT] button and press the [SCATTER]
button.
&
For details, refer to “SCATTER” (p. 38).