Roland Groovebox MC-707

35
Recording Knob Movement in Steps (MOTION)
Deleting Motion from a step
1.
While holding down the [SHIFT] button, press a step button.
The EDIT STEP screen appears.
2.
Press the cursor [<] button to select the “MOTION” tab.
3.
Use the MEASURE [<] [>] buttons and the step buttons to
select the step from which you want to delete Motion.
4.
While holding down the [CLEAR] button, press the [C1]–[C3]
knobs.
The Motion is deleted.
NOTE
If the [REC] button is lit, pressing the [CLEAR] button deletes the notes.
MEMO
You can also delete by turning the [C1]–[C3] knobs all the way to the left.
5.
When you have nished editing, press the [EXIT] button to
return to the home screen.
Inputting smooth Motion
(MOTION DESIGNER)
By using MOTION DESIGNER, you can input Motion data that changes
smoothly in time.
This function is a convenient way to create eects such as ducking
(side-chain).
1.
Select the Motion that you want to edit.
&
“Switching the Motion that’s edited or viewed by the step
buttons” (p. 34)
2.
In the EDIT STEP screen, press the [FUNC] button.
The screen indicates “UTILITY: MOTION DESIGNER.”
3.
Use the [C1]–[C4] knobs to adjust the parameters that you
want to input.
Controller Parameter Explanation
[C1] knob FORM TYPE
Selects the waveform of the time-
varying change.
[C2] knob STEP LENGTH
Species the number of steps from
beginning to end.
[C3] knob MIN VALUE
Species the minimum value of the
waveform.
[C4] knob MAX VALUE
Species the maximum value of the
waveform.
4.
Press the [ENTER] button.
Time-varying values are written as Motion for the specied knob.
5.
When you are nished editing, press the [EXIT] button to
return to the home screen.