Roland LEF-12 - Printable Area

Basic Operation
12
Chapter 1 Basic Operation Chapter 1 Basic Operation
Printable area
The maximum printable area is width 305 mm (12.01 in) x depth 280 mm (11.03 in) x height 100
mm (3.94 in).
* The maximum printable area is inside the guide lines on the at table.
* The maximum size of the media and the printable area are dierent.
How to Secure the Media
Procedure

Make sure the screen in the gure is displayed.
If it is not displayed, check that nothing has been placed
on top of the at table, and hold
for a long time.
The at table will come forward into a position in which the media
can be set up. If the screen in the gure is not displayed, you cannot
set up the media.

Secure the media in place.
For printing tests, use media for testing (width 80 mm (3.15 in) x length 70 mm (2.76 in) or more), and
not the media you will actually use.
SETUP MEDIA
Afx using tape
This method secures the media in place using com-
mercially available tape axed directly to the at table.
You can use this method to secure media when using
media, such as thin paper media, that can be secured
in place simply by taping it.
It can be set anywhere as long as it does not protrude
from the top of the at table. Be aware that when
there are folds or kinks in the media, they might hit the
interior of the printer and cause damage.
Flat table
(Front)
Length 280 mm
Width 305 mm
Media
Height
100 mm
Guide lines
Flat table