Roland LEF-12 - Set Height Position of Media (Automatic)

Basic Operation
13
Chapter 1 Basic Operation Chapter 1 Basic Operation
Set height position of media (automatic)
This setup sets the media’s height position automatically to a suitable position while printing. While setting
up, the at table moves automatically and detects the media height when the media touches the media gap
sensor.
* If the print surface is uneven, there is a limit to the area of unevenness.
 P. 39, "Height Settings When the Print Surface is Uneven"
When you do not want to let the media gap sensor to touch the media, automatic setup is not suitable in the
following cases. Set the height manually.
 P. 15, "Set height position of media (manual)"
Procedure

Secure the media in place on the at table.
 P. 11, "How to Secure the Media"

Close the front cover.

Press .
starts to ash.

Press to move the at table.
Move the print surface to a position 10 mm (0.39 in) away from the media gap sensor. This step can be
performed with the front cover open.
SETUP MEDIA
Media gap sensor
Media
10 mm
HEIGHT :  .  mm
Adhesive sheet
Media
Using an adhesive sheet
This method secures the media in place using an
adhesive sheet, which is included. Load the adhesive
sheet on the at table, and press the media on top of
the sheet to set.
It can be set anywhere as long as it does not protrude
from the top of the at table.