Roland LEF-12 - Start Printing

Basic Operation
22
Chapter 1 Basic Operation Chapter 1 Basic Operation
Start Printing
This section explains how to print from this machine, using the included VersaWorks (software RIP). It assumes
that you have already completed the following tasks.
 Installed VersaWorks
 Connected VersaWorks and this machine
 Learned the basic operation of VersaWorks
 "Roland VersaWorks Quick Start Guide" (included)
 Setup of media on this machine
 P. 13, "Set height position of media (automatic)"
 P. 15, "Set height position of media (manual)"
 P. 17, "Specify the print area directly"
 P. 19, "Specifying the Print Area from the Print Center Position"
 Prepared print data
This section uses data saved as a PS le.
For information on le formats that you can read directly with VersaWorks and on how to output from the
application, see "VersaWorks Quick Start Guide".
1. Load print area set on this machine into VersaWorks.

Launch VersaWorks.
Check that:
 VersaWorks connects to this machine
 Its status is "Ready to Print"

Double-click (or ).
A Input Property appears. (Open the property for the input setting to use.)