Fully Utilizing the Media Loading Feature
39
Chapter 2 Fully Utilizing the Machine Chapter 2 Fully Utilizing the Machine
Height Settings When the Print Surface is Uneven
This machine can also print on uneven surfaces. However, remember the following points for the height set-
ting.
Automatically set the height for the highest position of the media.
P. 13, "Set height position of media (automatic)"
Gap between "highest position of the media" and "lowest position of the print surface" should
be 2 mm or less (as a general guide).
Print quality at the lower position degrades as the height gap widens.
Printing on a surface that is perpendicular to print heads is not possible.
Highest position
of the media
Lowest posi-
tion of the print
surface
Max. 2 mm (as a
general guide)
Media
Printing on this surface is not
possible.
Print heads
Media
To Next Page
Loading...
