Roland LEF-12 - Fully Utilizing Preset Feature; Saving Current Media Setup with a Different Name

34
Chapter 2 Fully Utilizing the MachineChapter 2 Fully Utilizing the Machine
Fully Utilizing Preset Feature
Saving Current Media Setup with a Different Name
Procedure

Set up the media (height position, print area) and make sure is lit.

Press .

Press in this order to display the gure
on the left.
Press
.

Press to select among NAME1 through
NAME8.
Press
to enable the setting.
The current "height position of media" and "print area setting" are
saved.

Press to enter a character.
When you have decided on a character, press
.
The characters you can enter are "A" through "Z," "0" through "9," and
the "-" character. You can enter up to 15 characters, including spaces.

Press to enter the next character.
Enter the following characters in the same way.
When entries are completed, press to enable the
setting.

Press in this order to return to the origi-
nal screen.
Description
The following settings congured in media setup can be saved as up to a maximum of eight dierent types
of presets.
 Height position of media
 P. 13, "Set height position of media (automatic)"
 P. 15, "Set height position of media (manual)"
 Print area (including print-start position)
 P. 17, "Specify the print area directly"
 P. 19, "Specifying the Print Area from the Print Center Position"
You can assign a name to each preset. Using media names for these presets may aid recognition. These presets
eliminate the need to perform the setting when you are using media with the same shape. You can also use
presets and change just the print area, leaving the height setting unchanged.
 P. 35, "Load a Preset and Print/Fine-Tune and Print"
PRESET
SAVE
SAVE
NAME1
SET NAME
S_
SET NAME
SAMPLE_
W :  mm L :  mm
H :  .  mm
SETUP MEDIA