Roland LEF-12 - Page 35

Important points to check before printing
33
Chapter 2 Fully Utilizing the Machine Chapter 2 Fully Utilizing the Machine
4. Cover the margin areas of the at table with black sponge when you make a print on a 3D object
with a 10 mm or more height.
If the distance between the highest position of the print object (media) and the at table surface is 10 mm or
more, the UV lamp light is likely to be reected. Cover all the margin areas of the at table with black sponge
when you make a print on a 3D object with a 10 mm or more height. Cover the adhesive sheet with black
sponge as well if it is out of the print object (media).
When the height from the at table is 10 mm or more and the at table has margin areas even if a jig is used,
cover the at table surface with black sponge.
10 mm
or more
Black sponge
Print object
(media)
Adhesive sheetFlat table
Print object (media)
10 mm
or more
Black sponge
Flat table
Jig