85
Chapter 4 AppendixChapter 4 Appendix
Handling Messages and Error Messages
A Message Appears
These are the main messages that appear on the machine's display to prompt correct operation.
They do not indicate any error. Follow the prompts and take action accordingly.
[ 1 2 ■ 3 ■ 4 ■ 5 ■ 6 ■ ]
Only a small amount of ink remains. Replace the ink cartridge indicated by the ashing number with a new
cartridge.
[PRESS THE POWER KEY TO CLEAN]
This message appears when the machine has not been used for approximately a month. Turn on the sub
power once a month.
P. 52, "Introduction: About Maintenance"
[CIRCULATING INK]
White ink is being circulated inside the machine. This action is automatically performed to clear the white ink
precipitation. Wait until the displayed message changes.
[SET CARTRIDGE]
Insert the ink cartridge indicated by the ashing number. This message appears at times such as during ink
cartridge replacement.
[REMOVE CARTRIDGE]
Remove the ink cartridge indicated by the ashing number. This message appears at times such as during
ink cartridge replacement.
[SET CL-LIQUID]
Insert the SOL INK cleaning cartridge into the slot(s) indicated by the ashing number. This message appears
at times such as during head cleaning.
[REMOVE CL-LIQUID]
Remove the SOL INK cleaning cartridge indicated by the ashing number. This message appears at times such
as during head cleaning.
[CLOSE THE COVER (FRONT COVER or PANEL COVER) DRY-UP MAY DAMAGE THE
HEAD]
Close either the front cover and panel cover, or both. If the message is left displayed, the print head may get
dry, resulting in malfunction.
To Next Page
Loading...
