77
When Moving the Unit
Procedures from Preparing to Move Through Reinstalling
To move the machine, you must completely drain all ink inside the machine and secure the print heads in
place with packing materials to protect them. Attempting to move the machine without rst doing this may
result in damage to internal components due to leaking ink or damage to the heads.
This operation requires six unused SOL INK cleaning cartridges (four for cleaning and two for relling ink).
Have these on hand before you start.
Important Notes on Moving
Be sure to use SOL INK cleaning cartridges. Use of any other type may result in breakdown.
Once the preparations for moving are complete, move the machine and ll it with ink with as little delay
as possible. Allowing the machine to stand without ink may damage the print heads.
When moving the machine, keep it at a temperature between 5 to 40˚C (41 to 104˚F) and at relative humidity
between 20 to 80% (with no condensation). Failure to do so may result in breakdown.
Handle the machine with care when moving, keeping it level (not tilted at an angle) and preventing it from
striking other objects.
Procedure
Clean print heads.
Perform steps on P. 68, "Cleaning All Print Heads".
If the drain bottle and panel cover are detached, put them on.
Remove the stored packing.
Chapter 3 MaintenanceChapter 3 Maintenance
To Next Page
Loading...
