Fully Utilizing the Media Loading Feature
Chapter 2 Fully Utilizing the Machine
40
Chapter 2 Fully Utilizing the Machine
Even when the media comes into contact with the media gap sensor during printing, automatic adjustment is performed to continue printing.
Procedure
Press .
Press several times until the screen shown on
the left appears.
Press
.
Press several times until the screen shown on
the left appears.
Press
.
Press to select "RE-ADJ".
Press
to enable the setting
Press in this order to return to the origi-
nal screen.
Description
This function is eective for printing on media that cannot be redone. This setting allows the height to be
readjusted automatically to continue printing even when the media moves out of position or lifts up and
comes into contact with the media gap sensor during printing.*
However, the change of the height settings may cause lower printing image quality. (During automatic readjust-
ment, the media gap sensor will come into contact with the media as well. ) Hence, proper printing requires
properly securing the media before printing to keep it from moving out of position or lifting up.
P. 11, "How to Secure the Media"
P. 13, "Set height position of media (automatic)"
P. 15, "Set height position of media (manual)"
P. 17, "Specify the print area directly"
Even if "RE-ADJ" is selected, printing and setup will be canceled in the following cases.
In automatic readjustment, the at table descends more than 10 mm.
In automatic readjustment, even if the at table has moved to the bottom, the media comes into contact with the
media gap sensor.
If "CANCEL" is selected, printing and setup will be canceled without performing automatic readjustment. **
* For information on operation after printing is nished, refer to "[READJUST TABLE HEIGHT]" on P. 86.
**
For information on operation after printing is canceled, refer to
"[CANCELED FOR TABLE HEIGHT]" on P. 87.
Default Settings
[CLEARANCE MODE]: CANCEL
CLEARANCE MODE
CANCEL RE-ADJ.
W : mm L : mm
H : . mm
SETUP MEDIA
To Next Page
Loading...
