Roland LEF-12 - Media Loading and Print Area Setup

Fully Utilizing Preset Feature
35
Chapter 2 Fully Utilizing the MachineChapter 2 Fully Utilizing the Machine
Load a Preset and Print/Fine-Tune and Print
Procedure

Press .

Press twice.

Press to select the name of the preset
you want to load.
Press
to enable the setting.
The screen shown in the gure appears. goes dark.

Open the front cover and secure the media in place.
 P. 11, "How to Secure the Media"

Press .

The loaded preset setting is displayed.
To change the height setting of the media
Set height position of media.
 P. 13, "Set height position of media (automatic)"
 P. 15, "Set height position of media (manual)"
When choosing not to change the height setting of the media
Press .

The loaded preset setting is displayed.
To change the setting of the print area
Set the print area.
 P. 17, "Choosing How to Specify the Print Area"
 P. 17, "Specify the print area directly"
 P. 19, "Specifying the Print Area from the Print Center Position"
When the setup is completed, proceed to

.
When choosing not to change the setting of the print area
Press .

Press .

Press .

When the screen shown on the left appears, you can start printing.
Start printing.
 P. 22, "Start Printing"
MENU
PRESET
LOAD
NAME1
SETUP MEDIA
HEIGHT :  .  mm
PRINT POS. TYPE
CENTER
SCAN :  .  mm
FEED :  .  mm
WIDTH :  .  mm
LENGTH :  .  mm
W :  mm L :  mm
H :  .  mm