Roland LEF-12 - The Print Heads Do Not Move

Read this chapter whenever you face a problem. (FAQ)
Chapter 4 Appendix
84
Chapter 4 Appendix
The Print Heads Do Not Move
If the print-head carriage stops in the standby position (the right side of the main unit), take
action immediately to prevent the heads from drying out.
What to Do First
Switch the sub power o, and then back on again. If the
print-head carriage moves to the standby position (the
right side of the main unit), the operation has ended
successfully.
If the Heads Still Do Not Move
Try switching o the main power, then switching on the main power again, followed by the sub power.
If the Heads Still Do Not Move
If the heads still do not move, carry out the following emergency response measure, and then contact your
authorized Roland DG Corp. dealer.
Procedure

Turn off the main power switch.

Open the front cover.

Gently move the print heads into the stand-
by position by hand.
Stop when you hear the print heads click into place.

Close the front cover.