Basic Operation
25
Chapter 1 Basic Operation Chapter 1 Basic Operation
The white part in the layout area is the print area that was loaded in STEP
1.
. The portion that is not in the
print area will not be printed.
Use this screen to t the print data in the print area and adjust its position.
* This is an example when "Center on the Media" is selected.
The screen display appears in the opposite orientation.
The orientation in the VersaWorks screen display is the opposite of the actual print orientation. Make sure the
media orientation is correct.
Orientation on the
VersaWorks screen
Actual print orientation
Select [Fit to Media Size]
checkbox to adjust the print
data based on the print area.
Select [Center on the Me-
dia] checkbox to place the
print data in the center of
the print area.
Layout area
To Next Page
Loading...
