Periodic Cleaning Maintenance
63
Chapter 3 Maintenance Chapter 3 Maintenance
CAUTION
Be sure to perform operations as specied in the instructions above, and
never touch any area not specied in the instructions.
Sudden movement of the machine may cause injury.
1.
Change to the print-head manual-cleaning mode.
Remove any media. Close the front cover.
Press .
Press several times until the screen shown on
the left appears.
Press
.
Press
twice.
Press .
Important Notes on This Procedure
For manual cleaning, the cleaning liquid included, the cleaning stick, and a commercially available
glass cleaner are necessary. Please prepare them in advance.
Before performing this operation, remove any media.
To prevent the heads from drying out, nish this procedure in 10 minutes or less. A warning beep
sounds after 10 minutes.
Never use any implement other than the included cleaning stick. Cotton swabs or other lint-
producing items may damage the heads. If you use up the cleaning stick, purchase a new one
from your authorized Roland DG Corp. dealer.
Use one cleaning stick per cleaning session. Reusing cleaning sticks may reduce print quality.
Do not put a cleaning stick that has been used for cleaning into the cleaning liquid. It may dete-
riorate the uid.
Never rub the nozzle surface of the heads.
Stroke the sponges very gently, applying as little pressure as possible. Never rub, scrape, or crush
them.
When a warning beep sounds during cleaning
A warning beep sounds 10 minutes after operation begins. Stop work and close the front cover. And
then, press
to quit the manual cleaning menu. After that, restart the procedure from the
beginning.
To Next Page
Loading...
