3.1 OPERATING INSTRUCTIONS
DOC01-V6ULB+ 17
The recessed button locks all the device's movement functions on the remote
control and controls them fixed on the bed sides and at the foot of the bed,
except for the CPR function.
Chair function: places the bed in the chair position. This function tilts the back
and thigh section upwards, adjusts the height of the foot section upwards and
tilts the bed so that the foot section is lower than the head section.
Press this button until all functions have reached their maximum position.
Release to stop movement.
Note: the entire operation may take up to 60 seconds. The chair position is not
meant for foot end bed egress.
Electric CPR function: puts the bed in the optimum position for performing CPR
maneuvers. This function is to be used for this purpose ONLY.
Release the control to stop movement.
Light function: turns on the light under the bed.
Press to switch on and/or off
Call bell function: This function sends a signal to the nurses' station.
Press the button to send the signal.
Connection indicator: Indicates by means of an indicator light whether or not
the bed is connected to the wall socket. Allows the battery to recharge.
To Next Page
Loading...