Page 15 of 82 Revision No.: 1.5
1.1 My Farm
Fig. 8: Farm/Site option screenshot
a) Select option 1 from previous section and press 'ENTER'.
b) Insert the farm / site name using numeric text box keys (see Fig. 8).
1.2 Controller Port
Fig. 9: Local Network menu screenshot
Menu 1.2 (see Fig. 3) defines the basic applications and communication settings for
the Communicator (see Fig. 9). Wrong defenition can result alarms for missing
controllers or prevent communication from unidentefied controllers.
Fig. 10: Controllers Port option screenshot If yes RF there are jumpers > Appendix
Baud Rate setting must match all controllers otherwise the communication will not
operate. The default setting is 9600bps (see Fig. 10). Make sure the same rate is set to
all controllers both primary and secondary units connected to the communicator.
1.3 Serial Port
The serial port (see Fig. 11) connects between the Communicator and the PC
software. The baud rate set must be identical to the one set on the PC communication
software in order to establish communication. The default is also 9600bps. Note that
this is also being used for USB.
To Next Page
Loading...
