Page 16 of 82 Revision No.: 1.5
Fig. 11: Serial Port option screenshot
1.4 Test
Fig. 12: Modem menu screenshot
This menu helps you test communication between Primery controllers and the
communicator. Each controller is named by number, allowing the Communicator to
identify and test the connection with it (see Fig. 12).
1.4.1 RS232/RS485
Fig. 13: Communication option screenshot
In order to test comminication, insert the controller’s number and press 'ENTER'
to start / stop the test procedure (see Fig. 13). 'Tx' means “Transmited data” and
'Rx' means “Received data”. In order to indicate good communication both
indicators must flash allternaitly.
1.4.2 RF
Fig. 14: RF Test option screenshot
To Next Page
Loading...
