Page 34 of 82 Revision No.: 1.5
9.4 Test
Fig. 63: System Test menu screenshot
9.4.1 RS232/RS485
Fig. 64: Communication option screenshot
In order to test comminication, insert the controller’s number and press 'ENTER' to
start / stop the test procedure (see Fig. 64). 'Tx' means “Transmited data” and 'Rx'
means “Received data”. In order to indicate good communication both indicators must
flash allternaitly.
9.4.2 RF
Fig. 65: RF Test option screenshot
The RF test menu (see Fig. 65) checks the signal strength received from a certain
controller.
To Next Page
Loading...
