Page 17 of 82 Revision No.: 1.5
The RF test menu (see Fig. 14) checks the signal strength received from a certain
controller.
Fig. 15: RF screenshot
Set the controller's number in your network and press 'ENTER'. A signal strength is
received. Can be one of the six following options: "No Connection", "Very Low",
"Low", "Good", "Very Good" (see Fig. 15) and "Excellent".
Decent communication can be achived by low signal as well.
1.5 Network List
Fig. 16: Network List menu screenshot
In the menu (see Fig. 16) number of controllers detected by the communicator is
displayed.
Use the '+/-' key to change from 'NO' to 'YES' and press 'ENTER' to scan the network
for changes. The system will restart and rescan the network automatically. Make sure
all controllers are found in the menu list.
2. Regional Setting
Fig. 17: Regional Setting menu screenshot
The main purpose of this option is to adjust the communicator to the local phone
system, time and date (see Fig. 17).
3. Security
Use the security feature to protect your Communicator.
To Next Page
Loading...
