Rotem communicator - Voice Dial out to Contact List

Page 43 of 82 Revision No.: 1.5
8) Voice Dial Out to Contact List
• The Communicator dials to the contact list as defined.
If no contact list exists, the communicator does not dial.
• Once the controller alarm is triggered, a greeting voice message is
being read aloud: "Good <Morning/Afternoon/Evening> <poultry
farmer's name>, <farm name> farm. Please, press '1' to listen".
1. Press '1' to listen. If the user does not want to listen to the
message, the system repeats itself 3 times and only than will
automatically hang up.
2. After '1' is pressed the system proceeds to the following menu:
Press '*' to reset.
Press '1' to replay message.
Press '9' to go to the next message. If no further messages exist, the
system won't offer this option.
3. If '*' has been selected, the user must insert a password and in the
end to click '*'. If no password exists, the user must press '*' once
again.
4. After the password is inserted, the system repeats the alarms one
after the other and proceeds to the following menu:
Press '1' to disable the alarm.
Press '2' to enable the alarm.
Press '9' to go to the next alarm. Note that if no further messages exist, the
system won't offer this option.
Press '0' to exit this menu and go to the previous one.

At any time; if either an incorrect key is pressed or if nothing is
pressed, the system repeats itself 3 times and only than will
automatically hang up.