Page 41 of 82 Revision No.: 1.5
6) Network Setup
The purpose of this section is to support communication of up to 63 controllers,
whereas before it was possible to deal with maximum 32 controllers.
The parameter 'Primary' is set to be the number of controllers defined in the
communicator network. This parameter is divided to 2 branches;
o Lower branch – 1 to 32 controllers
o Upper branch – 33 to 63 controllers
Note that in order to be able to use the Upper branch, the Lower branch must be
defined entirely.
For example, if the controller number is 38, its lower controllers must be defined as 1
to 32.
Fig. 80 emphasis the controller numbers of both upper and lower branches.
Fig. 80: Hot key 0
To Next Page
Loading...
