Page 63 of 82 Revision No.: 1.5
4. Replace P-COMM-RF10-9-S COMMUNICATOR RF.
Voice Card
• Problem Description
Voice does not function
• Troubleshooting
4. If nothing of the above helps, contact your dealer.
Alarm
Problem Description
Receiving no messages from the communicator
Troubleshooting
3. Make sure the devices that function to report are functioning properly
Problem Description
Alarm LED is ON but the siren does not operate
Troubleshooting
3. Perform alarm relay test using menu 9.4.8 (see Fig. 3)
1. Go to menu 9.2 (see Fig. 3) and perform voice test, set the ‘volume’ and
‘speed’ parameters as requested. Don’t forget to confirm the selection by
moving the cursor to the ‘Test’ parameter and clicking the ENTER key.
2. Speaker cable is disconnected.
3. Volume trimmer is in Min. position, turn until desired volume is reached (see
Fig. 91).
1. Check if the active alarms are not defined in disable state.
2. Go over the contact group and make sure the users are not set to 'idle' and that
the group is written correctly.
2. Check the siren's connection to the relay (with battery – see Fig. 88).
To Next Page
Loading...
