Page 26 of 82 Revision No.: 1.5
Fig. 41: Reset screenshot
Fig. 42: Reset screenshot after clicking on '?' key
2. Press 'ENTER' to reset all active alarms.
7.2 Communicator
Fig. 43 presents the 'Communicator' menu.
Fig. 43: Communicator's menu screenshot
7.2.1 Reset
This menu is available if there is an active alarm (see Fig. 44). Note that the Reset is
meant only to the communicator's alarm. Fig. 44 represents "low battery" mode.
Note the following; an alarm has occurred and reset has been chosen. The system
goes to a delay mode where the alarm won't be back till 12:00 AM of the next day,
unless 'enable' to the alarm has been set. There is a possibility to define variables as
house number and alarm number and not to reset the alarm till a requested time.
Warning: When an alarm occurred and reset had been chosen, the system goes to a
delay mode where the alarm won't be back till 12:00 AM on the next day
To Next Page
Loading...
