Page 29 of 82 Revision No.: 1.5
This change triggers the alarm and the message “door opened” is sent to all addresses
programmed in Alarm/Options/Addresses.
8.1.2 Test
Fig. 50: Test selection screenshot
This screen enables testing of digital inputs plugged into the system (see Fig. 50).
Blank Squares represent open input and Full Squares represent a closed one. If you
connect a device to one of the inputs and it remains blank, it means a problem exists.
8.2 Relay
Fig. 51 presents the 'Relay' menu (menu 8.2, see Fig. 3).
Fig. 51: Relay menu screenshot
8.2.1 Setup
Fig. 52: Relays setting screenshot
This screen enables the user to set a code of a specific alarm that operates the relay
and its matching delay time in seconds (see Fig, 52).
To Next Page
Loading...
