Rotem communicator - Pager

Page 35 of 82 Revision No.: 1.5
Fig. 66: RF screenshot
Set the controller's number in your network and press 'ENTER'. A signal strength is
received. Can be one of the six following options: "No Connection", "Very Low",
"Low", "Good", "Very Good" (see Fig. 66) and "Excellent".
Decent communication can be achived by low signal as well
9.4.3 Pager
Use this option to calibrate your pager connection. There is a delay between the
service provider answer and the time the message has been sent to the pager (see Fig.
67-68).
Fig. 67: Test screenshot – part 1
Fig. 68: Test screenshot – part 2
Test the connection and use Menu 4.1.1 (see Fig. 3), 'Dial Delay' option in order to
change the number of seconds before sending the massage.
9.4.4 Dial Out
Use this menu to verify the proper connection of the line to the communicator (see
Fig. 69).
• Dial your number and answer the phone. Test text over the phone is heard and
the screen will display the message 'OK'.