Page 74 of 82 Revision No.: 1.5
Fig. 96: Pre-installer screenshot
2. Connect the USB cable between the host computer and the communicator. Connect
the communicator to its plug and finally connect the USB cable to the communicator.
3. Windows opens a “Found New Hardware Wizard” balloon message in the right
bottom of the screen.
4. Fig. 97 appears. Choose 'Install the software automatically (Recommended)'
option and click on 'Next' button.
Fig. 97: Hardware Wizard USB Communicator screenshot – part 1
5. Fig. 98 is seen. Click the 'Continue Anyway' button. If Windows asks about a
driver that is not signed as Windows XP driver, click 'Install Anyway' button.
To Next Page
Loading...
