Platinum Plus
33
Precision Mode Programming Guide
Where do I start?
Start with the Install Menu. Later programming steps can depend on
earlier steps. You can use this chart as a guide.
Precision Mode Programming Steps
Step 1 … 6. Install Menu Comments:
6.1
Install | Setup
Ventilation Mode ► Precision
Language ► English
Temperature Unit ► ºF
Static Pressure Unit ► Inches water
column
Fan Air Capacity Unit►CFM
Length Unit ►Feet
Baud Rate ► 9600
House Number, enter as required
Growing Zones, enter as required
Minimum Vent ► usually Yes
Natural Vent ► usually No
Tunnel Vent ► usually Yes
History Resolution ► for history
view, 1 minute to 1 day
1. Growing zones is the
number of sensor setups
including full house.
2. Minimum Vent includes
power ventilation through
transitional, but not natural
or tunnel.
3. History resolution applies
to History View in the
History Menu.
6.2
Install | Relay
Layout
Program the installed relays as the
electrician wired them.
1. Move the cursor to the relay to be
programmed.
2. Press ‘Enter’ to bring up the list of
relay types.
3. You can use the up/down arrow
keys to scroll through the list.
4. To move quickly to a relay type,
type the two digit code for the
relay.
5. For relay types past code 99, press
the +/- key first, then the two
digits.
6. You can use some codes only once
(heat, fan), and others any number
1. Radiant Heat Low operates
at a differential from Heat
Temperature. It can have
an associated high level
heater at a high level
differential and ignition
outputs.
2. AC/DC operation mode:
the AC mode keeps relays
on at half power instead of
full power to reduce heat
production.
3. Under Help | Set
Parameters, you can select
5 relays to operate in
reverse.
4. To move a single use relay
code such as heat from one
To Next Page
Loading...
