SME VoIP Handset guide
Proprietary and Confidential Page | 28
Line
If the handset is used in a multiline environment, it is possible to select preferred lines for the handset to make
outgoing calls from in the “Line” menu.
NOTE: To see additional information on this “Line” feature, please check the base system document via [2]
6.5.7 Reset Settings
The handset settings can be reset to default settings by selecting this menu “Reset settings”.
The handset PIN code is required to reset the handset. Following a reset the handset is still registered as the base
is not also reset to default when selecting this feature.
6.5.8 Status
The menu “Status” delivers some useful information to the end user about the base station that the handset is
currently using and the handset status.
The displayed information is as follows.
Base station:
- Software version (the current software version of the base station)
- Hardware version (the hardware version of the base station)
- IP address (the IP address of the base station)
- MAC address (the MAC address of the base station)
- System name (the name of the system of base stations that the handset is registered to)
Handset status:
- Software version (the current software version of the handset)
- Hardware version (the hardware version of the handset)
- DECT band (the DECT band that the handset is using, e.g. EU or US)
- Battery level (the current battery level of the handset)
- IPEI (the IPEI/IPUI number of the handset is a static number identifying the specific handset)
6.5.9 Auto Answer
In this menu it is possible to change the settings for auto answer on the handset.
To Next Page
Loading...
