2. Serial Protocols
ROS® v3.11User Guide 68 RMC30
TIN Mode:
Synopsis: 1 to 2
Default: 1
The TIN Protocol running mode.
TIN Transport:
Synopsis: { TCP, UDP }
Default: UDP
The network transport used to transport protocol data over an IP network.
WIN Transport:
Synopsis: { TCP, UDP }
Default: UDP
The network transport used to transport protocol data over an IP network.
TIN IP Port
Synopsis: 1024 to 65535
Default: 51000
The local port number on which the TIN protocol listens for connections or UDP datagrams.
WIN IP Port
Synopsis: 1024 to 65535
Default: 52000
The local port number on which the WIN protocol listens for connections or UDP
datagrams.
Message Aging Timer
Synopsis: 1 to 3600 or { Disabled }
Default: Disabled
The Aging Time for TIN mode2 messages. It specifies how long a message should be
stored in the internal table. When the feature is enabled, any TIN mode2 message received
will be stored in an internal table which can be examined by using command 'SQL SELECT
FROM ItcsTin2Dup'. If the same message is received within the time window specified by
this parameter, the new message is considered duplicate, and thus discarded.
Address Aging Timer
Synopsis: 60 to 1000
Default: 300 s
The time of communication inactivity after which a learned TIN address is removed from
the device address table. Entries in the Link Statistics Table with the aged address will be
kept until statistics are cleared.
Broadcast Addresses
Synopsis: { Static, Dynamic, StaticAndDynamic }
Default: Static
The device address table in which addresses will be found for broadcast messages.
Unicast Addresses
Synopsis: { Static, Dynamic, StaticAndDynamic }
Default: Dynamic
To Next Page
Loading...
Need help?
General