Appendix E. Command Line Listing
ROS® v3.11User Guide 133 RMC30
Appendix E. Command Line Listing
The following commands are available at the command line of ROS®-based RuggedSwitch®
and RuggedServer™ devices:
alarms Displays list of available alarms.
Usage: alarms [all]
all - display all alarm instances
(default empty) - display one instance of each alarm type.
arp Displays the IP to MAC address resolution table.
clearalarms Clears all alarms
clearethstats Clears Ethernet statistics for one or more port(s)
clearethstats ports|'all'
'ports' - comma separated port numbers (e.g. '1,3-5,7')
'all' - all ports
clearlogs Clears the system and crash logs
clrcblstats Clears Cable Diagnostics statistics for one or more port(s).
clrcblstats ports|'all'
ports - comma separated port numbers (e.g. '1,3-5,7')
'all' - all ports
clearstpstats Clear all spanning tree statistics.
cls Clears the screen
dir Prints file directory listing
exit Terminate this command line session
factory Enables factory mode, which includes several factory-level commands used
for testing and troubleshooting. Only available to admin users.
Misuse of the factory commands may corrupt the operational
state of device and/or may permanently damage the ability to
recover the device without manufacturer intervention.
flashfiles A set of diagnostic commands to display information about the Flash
filesystem and to defragment Flash memory.
Usage: flashfiles
Displays Flash memory statistics and Flash memory file system contents.
Usage: flashfiles info [filename]
Displays information about the specified file in the Flash filesystem.
Usage: flashfiles defrag
Defragments files in the Flash filesystem.
flashleds Flashes the unit LED indicators for the specified number of seconds.
Usage: flashleds timeout
timeout: the number of seconds to flash the unit LED indicators. To stop
flashing the LEDs, set timeout to 0 (zero).
help help [command name]
[command name] - Name of command for which to get help.
If no command is specified, a list of all available commands is displayed
along with a brief description of each one.
ipconfig Displays IP configuration
loaddflts Load Factory Default Configuration.
login Login to the shell i.e. set the access level
logout Logout of the shell
To Next Page
Loading...
Need help?
General