RuggedCom RuggedRouter RX1000 - Figure 30: Scheduled Commands Displaying a Command

Chapter 4 - Configuring The System
Begin by selecting the time and date you wish to run the command at using the Run
on date and Run at time fields.
Use the Run in directory field to enter a directory to run the command in, or simply
use “/”.
Finally, enter the command to execute in the Commands to execute field.
Note that the command will remain scheduled after reboot. After the command is
entered, the Scheduled Commands menu will display any commands and allow you
cancel them.
Figure 30: Scheduled Commands Displaying a Command
RuggedCom 45