RuggedRouter
®
User Guide
RuggedRouter Functions Supporting VLANs
Functions Supported
?
Comments
Static Route and Default
Route
Y
Static Multicast Routing Y
End To End backup Y
PPPoE N
Shorewall Firewall Y
IPSec N Netkey (policy based VPNs) supports VLAN
Klips (route based VLANs) do not support
VLAN
VRRP Y
Traffic Prioritization Y
Dynamic Routing Both OSPF and RIP support VLAN
GRE Tunnel Y
DHCP Server Y
PPPoE On Native Ethernet Interfaces Fundamentals
The RuggedRouter supports PPPoE (Point-to-Point Protocol Over Ethernet) over both
external modems (described here) and internal interfaces (described in the chapter
“PPPOE On ADSL”). The PPPOE On ADSL chapter contains more useful
information on PPPOE Authentication, Addresses, DNS Servers and MTU Issues.
Only one PPPoE interface can be created on each Ethernet Interface. Each PPPoE
interface name is assigned internally. The name is “pppX”, where X is 10 plus the
native Ethernet interface the PPPoE is created upon (e.g. a PPPoE on eth1 is ppp11).
58 RuggedCom
To Next Page
Loading...
Need help?
General
