Web-based Configuration Guide Network Settings
109
Enable the DHCP server function. After it is enabled, devices on the LAN can automatically
obtain IP addresses. After the DHCP service is enabled, you need to configure the start IP
address to be assigned, number of IP addresses to be assigned, and address lease term
for the DHCP server, and other DHCP server options. For details, see Configuring DHCP
Server.
Caution
VLAN configuration is associated with the configuration of the uplink device. Therefore, refer to the
configuration of the uplink device when configuring a VLAN.
4.7 Configuring Port VLAN
Caution
The port VLAN can be configured only when the device works in AP mode.
For RG-RAP2266 model: In Local Device mode, choose Network > LAN
For other RAP models: Choose ( WLAN > APs > Manage >) Network > LAN
(1) On the LAN Settings tab page, turn on Port VLAN, and click OK in the confirmation dialog box.
(1) Click Add. Enter the VLAN ID and description, and click OK to create a VLAN. The added VLAN is used to
set the VLAN, to which a port belongs.
To Next Page
Loading...
