Web-based Configuration Guide Fast Internet Access
4
1.5.1 Getting Started
(1) Connect the device to a power supply and connect the port of the device to an upstream device with an
Ethernet cable. Or you can connect an Ethernet cable to the device.
(1) Configure the Internet connection type according to requirements of the local Internet Service Provider (ISP).
Otherwise, the Internet access may fail due to improper configuration. You are advised to contact your local
ISP to confirm the Internet connection type:
○ Figure out whether the Internet connection type is PPPoE, DHCP mode, or static IP address mode.
○ In the PPPoE mode, a username, a password, and possibly a service name are needed.
○ In the static IP address mode, an IP address, a subnet mask, a gateway, and a DNS server need to be
configured.
(2) The device works in the AP mode by default. If you want to switch the work mode to the router mode, perform
the configuration on the work mode setting page. See Switching Work Mode for more details.
1.5.2 Configuration Steps
1. Add a Device to Network
You can manage and configure all devices in the network in batches by default. Please verify the device count
and network status before configuration.
To Next Page
Loading...
