Web-based Configuration Guide Fast Internet Access
5
Note
New devices will join in a network automatically after being powered on. You only need to verify the device
count.
If a new device is detected not in the network, click Add to My Network and enter its management password
to add the device manually.
2. Creating a Network Project
Click Start Setup to configure the Internet connection type, Wi-Fi network and management password.
(1) Network Name: Identify the network where the device is located.
(1) Internet: Configure the Internet connection type according to requirements of the local Internet Service
Provider (ISP).
○ DHCP: The access point detects whether it can obtain an IP address via DHCP by default. If the access
point connects to the Internet successfully, you can click Next without entering an account.
○ PPPoE: Click PPPoE, and enter the username, password, and service name. Click Next.
○ Static IP: Enter the IP address, subnet mask, gateway, and DNS server, and click Next.
(2) SSID and Wi-Fi Password: The device has no Wi-Fi password by default, indicating that the Wi-Fi network
is an open network. You are advised to configure a complex password to enhance the network security.
(3) Management Password: The password is used for logging in to the management page.
(4) Country/Region: The Wi-Fi channel may vary from country to country. To ensure that a client searches for
a Wi-Fi network successfully, you are advised to select the actual country or region.
(5) Time Zone: Set the system time. The network time server is enabled by default to provide the time service.
You are advised to select the actual time zone.
To Next Page
Loading...
