Web-based Configuration Guide Fast Internet Access
7
1.6.2 Configuration Steps
The device obtains the IP address through the DHCP by default. Configure the SSID, Wi-Fi password and
management password. The default Internet connection type is DHCP mode. You are advised to use the default
value.
1.7 Configuration Wizard (Wireless Repeater Mode)
1.7.1 Getting Started
Before configuring the wireless repeater mode, configure the primary router and test that the primary router
can access the Internet.
Place the device where it can discover at least two-bar Wi-Fi signal of the primary router.
Caution
No Ethernet cable is required in the wireless repeater mode. The wireless network stability can be
affected by many factors. Therefore, the wired connection is recommended.
1.7.2 Configuration Steps
(1) Connect the device to a power supply without connecting an Ethernet cable to the uplink port, and click
Start Setup.
To Next Page
Loading...
