Web-based Configuration Guide Network Settings
105
Select Access Point, click Check, confirm the Wi-Fi settings of the AP, and then click Save to expand the
network coverage.
Caution
After the configuration is saved, connected clients will be disconnected from the network for a short period of
time. You can reconnect the clients to the Wi-Fi network for restoration.
4.5.2 Wireless Repeater
The wireless repeater mode extends the Wi-Fi coverage range of the primary device. The device supports the
dual-link wireless repeater mode and can extend both 2.4 GHz and 5 GHz signals of the primary device.
Note
To avoid loops in wireless repeater mode, remove the network cable from the WAN port.
Obtain the Wi-Fi name and Wi-Fi password of the upper-layer router.
For RG-RAP2266 model: In Local Device mode, choose Network > Repeater Mode
For other RAP models: Choose ( WLAN > APs > Manage >) Network > Repeater Mode
(1) Click Wireless Repeater and then click Select. A list of surrounding Wi-Fi signals pops up. A list of nearby 5
GHz Wi-Fi networks is displayed by default. You can switch from 5 GHz to 2.4 GHz band by selecting 2.4G
from the drop-down list box. You are advised to select a strong 5 GHz Wi-Fi network signal.
To Next Page
Loading...
