Web-based Configuration Guide Network Monitoring
26
6. Enabling WAN Port
The WAN port works as the wired uplink port of the AP by default. For the AP added to the target network through
Mesh pairing, the WAN port is disabled by default. If you want to connect the Mesh AP to other downlink device
in wired mode to expand the network, enable this port.
(1) Log in to the eWeb of a device on the target network. In Network mode, choose Devices > AP and click the
serial number of the Mesh AP with the WAN port to be enabled.
(2) Choose More > Advanced > Enable WAN, toggle on Enable, and click Save.
7. Querying Mesh APs and Mesh Details
(1) Log in to the eWeb of a device on the target network.
(2) Query Mesh APs.
Method 1: In Network mode, check the topology on the Overview page. The AP that connects to the uplink
device in wireless mode is a Mesh AP.
To Next Page
Loading...
