Saab R5 - Long Range Configuration

R5 SOLID AIS System
OPERATION
7000 118-200, C2 Page 36
4.4.9 Main Menu  Config  Long Range
Parameter Name
Description
Reply Mode
When set to “Auto” the R5 SOLID will automatically
respond to any Long Range interrogation messages.
When set to “Manual” the operator is responsible for
sending a response or refusal to any Long Range
interrogation message. This can be done from the Long
Range view that is accessed from Main Menu 
Messages  Long Range. For more information see
section 4.14 “Long Range Interrogations”.
The information that is sent in a response is
automatically filled in by the R5 SOLID depending on
the Long Range filter settings (the parameters below).
Ship ID (A)
Filter setting that defines if a Long Range response
message should include ship name, call sign and IMO
number.
Message Date/Time (B)
Filter setting that defines if a Long Range response
message should include information about date and
time of message composition.
Latitude / Longitude (C)
Filter setting that defines if a Long Range response
message should include position.
Course Over Ground (E)
Filter setting that defines if a Long Range response
message should include COG.
Speed Over Ground (F)
Filter setting that defines if a Long Range response
message should include SOG.
Destination And ETA (I)
Filter setting that defines if a Long Range response
message should include destination and ETA.
Draught (O)
Filter setting that defines if a Long Range response
message should include draught.
Ship Type And Cargo (P)
Filter setting that defines if a Long Range response
message should include ship type and cargo
information.
Ship Size And Type (U)
Filter setting that defines if a Long Range response
message should include ship’s length, beam and type.
Persons On Board (W)
Filter setting that defines if a Long Range response
message should include number of persons on board.