© Safe Fleet | 2020 | All rights reserved | Part #: 700-1234 R1
DH4 Installation Guide
p. 23
DH4 Basic Conguration
Time/Display --> Monitor
Settings
If a Rear Vision Camera is installed, select monitor output settings.
Record Set the Record Delay Off to 15-20 minutes for post trip check.
If Wi-Fi is used, set the Power Delay Off to 2 hours for archive download.
Record --> Camera Turn off any unused camera channels, to avoid VLOSS events.
Alarms and Signals --> Alarms
Alarms and Signals --> Signals
can be set as signal outputs.
Alarms and Signals --> Speed
Alarms and Signals --> (DH4
external G Sensor)
If a G Sensor is installed, Calibrate.
Network If an external Smart-Reach WiFi bridge is used, set addresses as instructed by an
IT administrator. Use the IP address shown to communicate with the DVR over the
network with vMax Web.
Network Advanced
settings as instructed by an IT administrator.
Network Advanced WIFI
If the DH4 built-in WIFI is used, enter WIFI settings as instructed by an IT administrator.
System Select the adio channel to output from the DVR audio RCA socket.
If an RGY button or Diagnostic indicator is installed, select it here.
System --> Program Update
Format the hard drive after all settings have been made.
To Next Page
Loading...