Safe Fleet DH4 - Fi; Network Settings

© Safe Fleet | 2020 | All rights reserved | Part #: 700-1234 R1
DH4 Installation Guide
p. 36
DH4 Advanced Conguration
Network Settings
 Note: Conguring Network Settings and Advanced Network settings
• Each host (computer) connected to the network must have a unique IP address.
• 
be updated. For more information, see DH4 Conguration: Copying DVR Conguration.
Contact Safe Fleet Engineering Services or Technical Support to assign an IP address or reset the Smart-Reach Mobile
wireless bridge, or for more information.
:
1. Select Network to open the tab.
2. Menu
Options, below.
3. Click Back
menu.
 Note: Conguring WIFI
• If the DVR's built-in WIFI is used, see "Built-in WIFI Settings" on page 39.
• If the DVR is attached to an external WIFI bridge, update the Network Settings tab with information supplied by the
system administrator, as shown below.
 Caution: Qualied personnel only
-
work settings.
