LRF 6019 Integrator Manual
914928_TML_LRF6019_en_Version C
Confidential & Proprietary Safran Vectronix AG – All rights reserved
Figure 9: LRF 6019 with interface cable connected to the Samtec System Connector
The USB Driver for the FTDI USB to Serial Converter used by the interface cable can be selected
and downloaded under the following link: http://www.ftdichip.com/Drivers/VCP.htm
For Windows 7 and new systems, please download and install this driver:
http://www.ftdichip.com/Drivers/CDM/CDM21218_Setup.zip
An installation guide for the driver can be found here:
http://www.ftdichip.com/Support/Documents/InstallGuides.htm
3.3 Installation of Vectronix Terminal Software
A USB Stick with the Vectronix Terminal Software is included in the Interface Kit (Article No 914752).
Please follow the steps below to install the LRF Terminal Software.
1) Connect the USB-Stick to your PC.
2) Open the “setup.exe” file on the USB-Stick.
3) Select your installation language (English selected as an example).
4) At the welcome screen, click “Next” to continue.
To Next Page
Loading...
Need help?
General
