Earphone Volume
If you select Earphone as the audio output device, use this
option to set how loud the prompt is when using an earphone or
headset. If you need to change the volume level, slide your
finger along the Earphone Volume bar or tap the bar at a
specific point. Then choose OK.
Excessive volume or sound pressure level when using
earphones or headphones can cause hearing loss over
extended periods of time.
Scanning Beep
If you prefer to hear a beep instead of an auditory prompt when
you scan a key, select the Scanning Beep option.
Button Prompt
This option determines whether the label or message is spoken
as the button prompt. To change the setting, choose Button
Prompt and select either Speak Label or Speak Message.
Choosing a Voice
Choose a voice to use for the auditory prompts. It can be helpful
to choose a different voice for the prompt than the one the
system uses for speaking messages.
To change the voice, choose Voice Settings, then tap the arrow
to the right of the currently selected voice to open a list of
voices. Choose the voice you want. If necessary, adjust the
voice’s pitch or talking speed:
1. Slide your finger along the Pitch or Rate bar or tap a bar at a
specific point.
2. Tap Test to make sure that you selected the pitch or rate you
want.
3. If not, adjust the setting and tap Test again.
4. When the voice is set the way you want, tap Save.
Note: If you want to set an auditory prompt for a row, see
“Adding Row Prompts
”.
NOVA chat User’s Guide 10022 Dedicated Version 1.4 Page 80
To Next Page
Loading...
