Sam4s ER-230 - Program 250 - PLU Stock Amount Programming

Sam4S 230, 3xx, 4xx, 52xx Electronic Cash Register AU Program Mode Programming • 151
Program 250 - PLU Stock Amount Programming
With this program, you can add stock to the PLU sales counters for PLUs you have designated as
stock keeping PLUs. See “Program 100 - PLU Status Programming”. The stock number set here
can be the amount of stock that is being added to the current level, or optionally, it can be the new
total stock level. See option #18 in "Program Mode Programming – System Option
Programming" to set this option.
Programming PLU/PLUs Stock Amount
1. Turn the control lock to the PGM-Mode.
Switch to P Mode by press MODE function key. (For ER-230)
2. To begin the program, enter 2 5 0, press the SUBTL key.
3. Select the PLU or PLUs you wish to program in one of the following ways:
• Press a PLU on the keyboard, or
• Press the first PLU in a range of PLUs that are to receive the same setting then press
the last PLU, or
• Enter up to 15 digit number of the PLU and press the PLU key, or
• Enter the number of the first PLU in a range of PLUs that are to receive the same
setting; press the PLU key. Enter the last PLU number in the range; press the PLU
key, or
• For a barcode item, scan the barcode. (Only for single item.)
4. Enter the stock amount you wish to add (up to six digits. Please do not use decimal
point. When 1 0 0 is entered, is equals to 1 item), press the X/TIME key.
5. To program additional PLU Stock Amount, repeat from step 3, or press the CASH key
to finalise the program.
CASH
0 SUBTL5 2
PLU
PLU
PLU
PLU
Enter the PLU#,
up to 15 digits
PLU
Enter the first PLU#,
up to 15 digits
Enter the last PLU#,
up to 15 digits
PLU
X/TIME
Stock Amount