Sam4s ER-230 - Program 801 - Drawer Assignment & Training Clerk Programming

Sam4S 230, 3xx, 4xx, 52xx Electronic Cash Register AU Program Mode Programming • 219
Program 801 - Drawer Assignment & Training Clerk Programming
Programming the Drawer Assignment & Training Clerk
1. Turn the control lock to the PGM-Mode.
Switch to P Mode by press MODE function key. (For ER-230)
2. To begin the program, enter 8 0 1, press the SUBTL key.
3. Enter the number of the clerk you wish to program; press the X/TIME key.
4. Enter an option digit from the table below, press the SUBTL key.
Address OPTION VALUE = SUM
N1
ER-230
ER-3xx
ER-4xx
Drawer assignment
(0: default drawer, 1: no drawer)
0*
ER-52xx
Drawer assignment
(0: default drawer, 1:second drawer,
2: no drawer)
N2
Train Clerk
Yes = 1
No = 0
ÚDefault values have been highlighted in bold print
5. To program additional Clerk Drawer Assignment & Training Clerk, repeat from step
3, or press the CASH key to finalise the program.
NOTE: When set to ‘0’ for default drawer, will show ‘1’ on the Program Scan - Clerk Scan,
‘1’ will show ‘2’, ‘2’ will show ‘0’.
CASH
N2 SUBTLN1
X/TIME
1 SUBTL0 8