226 • Program Mode Programming Sam4S 230, 3xx, 4xx, 52xx Electronic Cash Register AU
Program 700 - Logo Description Programming
Program descriptions by typing description on the alpha keyboard overlay or by entering three digit
alpha character codes. To descript by three digit alpha character codes you must select ‘No’ in
system option #25(for ER-3xx Series)/#30(for ER-230, ER-4xx and ER-52xx Series) (See
“System Option Programming). Also see Descriptor Programming Methods for Alpha Overlay
and/or Descriptor Code Table.
Programming the Receipt/Check/Endorsement Message
A preamble message of up to six lines can be printed at the top of each receipt; a postamble
message of up to six lines can be printed at the bottom of each receipt: a endorsement
message of up to ten lines can be printed when a check is endorsed on an optional slip printer.
Each line can consist of up to 32 characters for Sam4S 230, 3xx and 52xx Series and 24
characters for Sam4S 4xx Series Electronic Cash Registers.
1. Turn the control lock to the PGM-Mode.
Switch to P Mode by press MODE function key. (For ER-230)
2. To begin the program, enter 7 0 0, press the SUBTL key.
3. Refer to the chart below and enter the number that represents the line you wish to
program; press the X/TIME key.
X Message Line X Message Line X Message Line
1
1
st
line of Preamble
9
3
rd
line of Postamble
17
5
t
line of Endorsement
7
1
st
line of Postamble
15
3
rd
line of Endorsement
8
2
nd
line of Postamble
16
4
th
line of Endorsement
4. If you are programming using alpha overlay, type up to 32 descriptors on the overlay
and press the SUBTL key.
or,
If you are programming using descriptor codes, enter up to 18 three-digit character codes
and press the SUBTL key.
5. To program additional Logo Descriptor, repeat from step 3, or press the CASH key to
finalise the program.
CASH
Type up to 32 / 24 (ER-4xx)
descriptor keys
SUBTL
SUBTL
Enter up to 32 / 24 (ER-4xx)
three-character codes
0 SUBTL0 7
X X/TIME
To Next Page
Loading...
