Chapter 3. Installing the Product 3 - 9
System Power
Boot up the system for use.
Turning the Power On
While the power is turned off, press the On/Off button. Booting will start, and the product logo
will be displayed on the screen. When booting is complete, a 2D mode screen will be displayed
in End Exam state.
NOTE
If the power switch near the power connection port on the rear panel
of the product has been switched off, wait for 10 seconds before
turning on the product.
While the system is booting, do not press buttons on the keyboard,
and make sure that there are no objects sitting on the keyboard
buttons; otherwise the system may not work correctly.
If you forcefully turn off the power and then turn on the product
again, the system may momentarily turn on and then turn off again.
This is a characteristic of the Intel
®
PC main board contained in the
product, and not a system error.
CAUTION
Before turning the power on, connect the probes and peripheral devices
you want to use. Connecting them while you are using the product may
injure the patient or severely damage the product.
CAUTION
Before starting the diagnosis, you must register the patient information.
To Next Page
Loading...